柴油车尾气处理液颗粒原料尿素指标研究

以颗粒尿素为原料生产的柴油车尾气处理液,在气温低的地区使用易出现沉淀物问题,通过对尿素生产工艺的研究和试验分析得知,沉淀物产生的原因为尿素生产蒸发造粒时产生的副产物缩二脲等所造成,当颗粒尿素中的副产物含量偏高时,遇低温就会析出,且该析出反应不可逆;通过进一步试验确定,当固体尿素为原料生产柴油车尾气处理液选用的颗粒尿素原料缩二脲≤0.80％时,是生产尾气处理液产品不出现析出物的关键性指标.目前,该指标已为大多数以颗粒尿素生产柴油车尾气处理液的生产厂家所选用采纳.     

A fuzzy logic PI control with feedforward compensation for hydrogen pressure in vehicular fuel cell system

In a vehicular fuel cell system, alternative load and frequent purge action can lead to anode pressure varies with the hydrogen mass flow fluctuation. It's crucial to control the pressure difference between anode and cathode within a reasonable range to avoid adverse phenomena such as membrane failure, reactant starvation, or even water management fault. In this paper, an improved proportional integrative (PI) controller by the fuzzy logic technique that considers the engineer experience and knowledge on the hydrogen supply system behavior is proposed for hydrogen pressure control, in which the PI parameters are tuned by a fuzzy decision process. Furthermore, load current and purge action regarded as input disturbances are applied for feedforward compensation to reduce the pressure response hysteresis. A hydrogen supply subsystem based on the proportional valve is modeled, and corresponding parameters are determined by analyzing the response time and steady pressure fluctuation. The performance of the conventional PI controller, the fuzzy logic PI (FLPI) controller and fuzzy logic PI with feedforward (FLPIF) controller is validated. The presented results indicated that the FLPI controller significantly improves the dynamic response of hydrogen pressure compared to the PI controller, and the FLPIF controller can further reduce overshoot caused by disturbance. Finally, the proposed FLPIF controller is implemented on a rapid prototype platform of the hydrogen supply subsystem and an actual fuel cell system, exhibiting satisfactory performance.     

Nickel supported over MCM-41 coated ceramic membrane for steam reforming of real tar

A novel catalyst, Nickel supported over MCM-41 coated ceramic membrane (NMC), was developed using coating method and deposition-precipitation method and applied for steam reforming of real tar in fixed bed. The effects of reaction conditions such as Ni loading amount, reaction temperature and mass ratio of steam to tar were also studied. The good dispersion of Ni nanoparticles and the strong interaction between Ni particles and the support were identified by BET, XRD, H₂-TPR and SEM/EDS, resulting in the excellent performance of NMC catalysts. Maximum tar conversion of 96.4% and H₂ yield of 98.7 mmol g^?1 were obtained using 20NMC with a mass ratio of steam to coal tar of 2 at 800 °C. Moreover, 20 NMC exhibited a good stability in 10 h of lifetime test and the resistance of graphitic carbon formation prone to easier regeneration of catalysts illustrated by Raman spectroscopy. It indicates that the utilization of NMC catalysts for tar steam reforming is a promising way.     

Adaptive finite-time tracking control for parameterized nonlinear systems with full state constraints

In this article, the issue of adaptive finite-time dynamic surface control (DSC) is discussed for a class of parameterized nonlinear systems with full state constraints. Using the property of logarithmic function, a one-to-one nonlinear mapping is constructed to transform a constrained system into an unconstrained system with the same structure. The nonlinear filter is constructed to replace the first-order linear filter in the traditional DSC, and the demand on the filter time constant is reduced. Based on finite-time stable theory and using modified DSC, the finite-time controller is designed via DSC. Theoretical analysis shows that all the signals in the closed-loop system are semiglobal practical finite-time stable. Furthermore, none of the states are outside the defined open set. In the end, simulation results are presented to demonstrate the effectiveness of the proposed control schemes with both linear filters and nonlinear filters.     

Electrocaloric effect and pyroelectric energy harvesting in diffuse ferroelectric Ba(Ti 1-x Ce x )O 3 ceramics

In the present work Ba(Ti1-xCex)O3 ceramics are prepared through a standard solid-state sintering process. Crystal structures, dielectric properties, ferroelectric properties and electrocaloric...     

Ni-Foam Structured Ni-Phyllosilicate Ensemble as an Efficient Monolithic Catalyst for CO2 Methanation

This work proposed a new path to synthesize Ni-phyllosilicate through the reaction of nickel hydroxide and silica sol on the surface of Ni-foam to form the monolithic Ni-phyllosilicate/Ni-foam catalyst. Ni-phyllosilicate could reprint the morphology of nickel hydroxid and firmly anchor on the framework of Ni-foam, which obtained fine Ni particles of 2.8 nm after reduction in H₂ at 650 °C, resulting in high catalytic activity for CO₂ methanation. In addition, the Ni-phyllosilicate/Ni-foam catalyst showed high long-term stability in a 100 h-lifetime test owing to the combined effects of surface confinement of Ni-phyllosilicate, firm anchoring between Ni-phyllosilicate and Ni-foam, as well as the high heat transfer property of Ni-foam.

Graphical Abstract

     

Tuning the magnetic properties of Zr2N MXene by biaxial strain

The effects of strain on the magnetic properties of Zr₂N MXene have been investigated by the first-principles calculations. The ground state of strain-free Zr₂N MXene is intrinsically antiferromagnetic. However, the magnetic state of Zr₂N MXene tends to be ferromagnetic when the applied strain is higher than 4%. The transition of magnetic orderings from antiferromagnetism to ferromagnetism under tensile strains can be understood from the Stoner criterion. Besides, the critical temperature (T_c) is about 470 K for the strain-free Zr₂N MXene, indicating that the antiferromagnetic ordering can be robust and maintained at room temperature. The T_c of antiferromagnetic states begins to decrease once the strain is exerted. As the FM ordering is favored, however, the T_c then increases with the applied strain. Under 8% tensile strain, the T_c comes to room temperature (300 K). In addition, both the orientation of easy-axis and the magnetic anisotropy energy (MAE) of Zr₂N MXene fluctuate with the strain. At the strain of 2%, the MAE reaches the largest (203 μeV per Zr atom), mainly resulting from the spin-orbit interactions between occupied and unoccupied p_x/p_y states of Zr atoms. All these tunable and appealing properties make Zr₂N MXene desirable for spintronic applications.     

Suppression of Hypoxia-Inducible Factor 1α by Low-Molecular-Weight Heparin Mitigates Ventilation-Induced Diaphragm Dysfunction in a Murine Endotoxemia Model

Mechanical ventilation (MV) is required to maintain life for patients with sepsis-related acute lung injury but can cause diaphragmatic myotrauma with muscle damage and weakness, known as ventilator-induced diaphragm dysfunction (VIDD). Hypoxia-inducible factor 1α (HIF-1α) plays a crucial role in inducing inflammation and apoptosis. Low-molecular-weight heparin (LMWH) was proven to have anti-inflammatory properties. However, HIF-1α and LMWH affect sepsis-related diaphragm injury has not been investigated. We hypothesized that LMWH would reduce endotoxin-augmented VIDD through HIF-1α. C57BL/6 mice, either wild-type or HIF-1α–deficient, were exposed to MV with or without endotoxemia for 8 h. Enoxaparin (4 mg/kg) was administered subcutaneously 30 min before MV. MV with endotoxemia aggravated VIDD, as demonstrated by increased interleukin-6 and macrophage inflammatory protein-2 levels, oxidative loads, and the expression of HIF-1α, calpain, caspase-3, atrogin-1, muscle ring finger-1, and microtubule-associated protein light chain 3-II. Disorganized myofibrils, disrupted mitochondria, increased numbers of autophagic and apoptotic mediators, substantial apoptosis of diaphragm muscle fibers, and decreased diaphragm function were also observed (p < 0.05). Endotoxin-exacerbated VIDD and myonuclear apoptosis were attenuated by pharmacologic inhibition by LMWH and in HIF-1α–deficient mice (p < 0.05). Our data indicate that enoxaparin reduces endotoxin-augmented MV-induced diaphragmatic injury, partially through HIF-1α pathway inhibition.     

High-entropy ferroelastic rare-earth tantalite ceramic: (Y0.2Ce0.2Sm0.2Gd0.2Dy0.2)TaO4

In this study, high-entropy rare-earth tantalate ceramics (Y_0.2Ce_0.2Sm_0.2Gd_0.2Dy_0.2)TaO₄ ((5RE_0.2)TaO₄) have been successfully fabricated. The possibility of formation of (5RE_0.2)TaO₄ was verified via first-principles calculations. In addition, the phase structure, ferroelastic toughening mechanism, thermophysical, and mechanical properties were systematically investigated. The (5RE_0.2)TaO₄ ceramics have lower phonon thermal conductivity (1.2–2.6 W·m^–1·K^–1) in the entire temperature range than that of RETaO₄ and YSZ. (5RE_0.2)TaO₄ has a higher fracture toughness and lower brittleness index than YSZ. The thermal expansion coefficients of (5RE_0.2)TaO₄ are as high as 10.3 × 10^-6 K^–1 at 1200°C and Young's modulus is 66–189 GPa, and thus, (5RE_0.2)TaO₄ possesses great potential for application in thermal barrier coatings (TBCs).     

Biomimetic Lamellar Chitosan Scaffold for Soft Gingival Tissue Regeneration

Mucogingival surgery has become a common procedure for soft gingival tissue reparation in dental clinical practice, which mainly relies on autograft or commercial collagen membranes (CM). However, the autograft faces grand challenges in source availability and long-term post-surgery pain management, and the CM is restricted by its poor mechanical properties in an aqueous environment. Here, it is reported that a bio-inspired lamellar chitosan scaffold (LCS) with long range ordered porous structure, manufactured through a bidirectional freezing method, can serve as a promising gingival tissue engineering material. The LCS not only exhibits excellent mechanical properties in the hydrated state but also accelerates vessel formation and soft tissue regeneration in vivo. Most interestingly, the LCS is found to be capable of inducing macrophage differentiation to M2 macrophages, which is thought to play an important role in tissue regeneration. These advantages combined with its easy and low-cost preparation process make the LCS a promising candidate for dental clinical applications.